Chocolate Bar Crimp - Set of 6
Finger plates for Kachi-tore (a type of climbing training) in a chocolate bar design.
These are plastic holds produced using a 3D printer.
Set of 6 pieces in 8mm, 10mm, and 12mm sizes.
You can feel some friction even without chalk.
Using chalk or PD9 together will provide sufficient friction.
⚠️ Precautions for Use
These holds are less durable than generally molded resin or urethane holds.
The creator uses them daily and has not experienced any major issues so far.
Overtightening screws can cause breakage. Please be careful not to overtighten when installing.
These are plastic holds produced using a 3D printer.
Set of 6 pieces in 8mm, 10mm, and 12mm sizes.
You can feel some friction even without chalk.
Using chalk or PD9 together will provide sufficient friction.
⚠️ Precautions for Use
These holds are less durable than generally molded resin or urethane holds.
The creator uses them daily and has not experienced any major issues so far.
Overtightening screws can cause breakage. Please be careful not to overtighten when installing.
Category
Mountain Climbing / Climbing Supplies
Condition
No noticeable scratches or marks
Shipping
Included in price (by seller)
From
Kanagawa
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
