Climbing Holds Set of 5

This is a set of 5 climbing holds.
Made from plastic using a 3D printer.
Brushes are for size comparison only and are not included.

[Product Features]
These are 20mm holds, each with a different undercut percentage.
The feeling of grip changes depending on which hold you use, so try them out in different situations.
Recommended angle: -110 degrees

[About Friction]
We pay close attention to printing settings and materials, so even though they are 3D printed, you can feel the friction.
They may feel slippery at first, but once chalk is applied, you can climb without issue.

⚠️ Precautions for Use
The strength is inferior compared to general resin molded or urethane holds.
The creator uses them daily and has not encountered any major problems so far.
Overtightening the screws will cause damage. Please be careful not to overtighten when installing.

Use at your own risk.