Animal Crimp - Hippopotamus

This is a hippo-shaped climbing hold. The nose area is designed to be gripped.
Made from plastic using a 3D printer.
The brush is for size comparison only and is not included.

While it's a cute hold, the grip is not great.
The creator was able to do a pull-up on it.

If you purchase multiple items, we can offer a discount of up to 1500 yen.

Recommended angle: -110 degrees

[About Friction]
We pay close attention to printing settings and materials, so even though it's 3D printed, you can feel the friction.
It may feel slippery at first, but once chalk is applied, you can climb without issue.

⚠️ Precautions for Use
The strength is inferior compared to general resin molded or urethane climbing holds.
The creator uses it daily and has not experienced any major problems so far.
Overtightening the screws will cause damage. Please be careful not to overtighten when installing.

Use at your own risk.