Climbing Pre-clip Selfie Stick Attachment Chonbo Stick

We have uploaded a video demonstrating its use on YouTube.
Please search for プリクリップ棒 3Dプリンタ (Pre-clip stick 3D printer) and watch it.

There are two ways to use it.
1. Attach the nunchucks with the rope already on them.
As shown in photos 3 and 4, open the carabiner gate, hook it, and pull diagonally downwards to close the gate.

2. Attach the rope to the nunchucks that are already attached.
As shown in photos 1 and 2, with the rope around the gate, pull one side of the rope to push open the gate and attach it.
[Tips for Use]
- When lifting, the rope may slip due to its weight, so hold the rope (both sides) together with the stick.
- When attaching to the gate, hold one side of the rope with the stick, and pull the other side of the rope with your other hand.

This product is compatible with the standard 1/4 inch screw found on selfie sticks for action cameras, etc.
*You can find selfie sticks for around 1000 yen by searching for 1/4 selfie stick on Amazon, etc. Please choose a type with a swivel function.
(We also have a separate listing for a type that attaches to the tip of a PAMO brush.)

Can be used with both wire gate and keylock gate carabiners.
*Photos 6 and 7 show only the pre-clip attachment; nunchucks and sticks are not included.

It can be used without issue if the gate width is approximately 11-12mm, but we can also create it for other sizes upon request.

As this is a 3D printed product, please excuse any minor imperfections like burrs that do not affect functionality.

Free climbing, alpine climbing, Petzl, Black Diamond, Metolius, quickdraw, draw, clip stick, quickdraw, cam, gear