Climbing Holds Set of 8
Climbing Holds Set of 8
These are finger plates for Kachi-Tore training.
3D printed.
Material: Plastic (PLA-CF)
Size: 30mm (Height) x 90mm (Width) x 6mm, 8mm, 10mm, 12mm (Thickness)
The top surface is flat, inspired by BEAST MAKER's friction, while the opposite side is designed to mimic the feel of Kachi-hold grips for technique training. They can be used in two ways by changing the mounting orientation.
They can be used even without chalk.
Precautions for Use
Overtightening screws can cause damage, but the material strength is high, so it is unlikely to break under normal use.
Please use at your own risk.
These are finger plates for Kachi-Tore training.
3D printed.
Material: Plastic (PLA-CF)
Size: 30mm (Height) x 90mm (Width) x 6mm, 8mm, 10mm, 12mm (Thickness)
The top surface is flat, inspired by BEAST MAKER's friction, while the opposite side is designed to mimic the feel of Kachi-hold grips for technique training. They can be used in two ways by changing the mounting orientation.
They can be used even without chalk.
Precautions for Use
Overtightening screws can cause damage, but the material strength is high, so it is unlikely to break under normal use.
Please use at your own risk.
Category
Mountaineering & Climbing Supplies
Condition
New/unused
Shipping
Included in price (by seller)
From
Hyogo
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
