Climbing Holds Set of 6
Climbing Holds - Set of 6
Get up to 10% off when you buy in bulk. Please feel free to contact us for details.
These are finger plates for Kachi-Tore training.
Manufactured using a 3D printer.
Material: Plastic (PLA-CF)
Size: 30mm (height) x 90mm (width) x 8mm, 10mm, 12mm (thickness)
The top surface is flat, inspired by the friction of BEAST MAKER holds, while the opposite side is designed to mimic the feel of Kachi-hold for technique training. They can be used in two ways by changing the mounting orientation.
They can be used even without chalk.
Precautions for Use
Overtightening screws can cause damage, but the material is strong, so it is unlikely to break under normal use.
Please use at your own risk.
Get up to 10% off when you buy in bulk. Please feel free to contact us for details.
These are finger plates for Kachi-Tore training.
Manufactured using a 3D printer.
Material: Plastic (PLA-CF)
Size: 30mm (height) x 90mm (width) x 8mm, 10mm, 12mm (thickness)
The top surface is flat, inspired by the friction of BEAST MAKER holds, while the opposite side is designed to mimic the feel of Kachi-hold for technique training. They can be used in two ways by changing the mounting orientation.
They can be used even without chalk.
Precautions for Use
Overtightening screws can cause damage, but the material is strong, so it is unlikely to break under normal use.
Please use at your own risk.
Category
Mountain Climbing / Climbing Supplies
Condition
New/unused
Shipping
Included in price (by seller)
From
Hyogo
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
