Grip for Fujifilm X-half
This is a case and grip for the Fujifilm X-half (x-hf1). (The camera body shown in the photo is not for sale.)
Since the bottom of the Xhalf scratches easily, I made a cover/grip myself.
The material is plastic output from a 3D printer, and I believe the strength is sufficient.
Personally, I am satisfied because it attaches perfectly without screws, can be used normally, and provides a sense of security and grip.
Shipping will be via Yu-Packet Post Mini, so it will be in simple packaging.
Since the bottom of the Xhalf scratches easily, I made a cover/grip myself.
The material is plastic output from a 3D printer, and I believe the strength is sufficient.
Personally, I am satisfied because it attaches perfectly without screws, can be used normally, and provides a sense of security and grip.
Shipping will be via Yu-Packet Post Mini, so it will be in simple packaging.
Category
Digital Camera
Condition
New/unused
Shipping
Included in price (by seller)
From
Kanagawa
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
