AC 5V USB Thermostat Temperature Control for Cats, Pets, Heater Mats, etc.

New item
Made for a heated mat for rescued cats.

Input: AC adapter DC jack (5V)
Output: USB (5V)

Temperature sensor length is approximately 98cm.

Designed for heaters.
This is a thermostat that automatically turns off when the set temperature is reached.

Please note that this is for standard 5V use and cannot be used with PD.

Red temperature = Current temperature
Blue temperature = Temperature to turn off power

How to use:
- Press the SET button to unlock.
- Use the up/down buttons to set the temperature.

Long-press the SET button to change various modes.

P0 (Heater or Cooler)
- H = For heater
- C = For cooler

P1 (Temperature Hysteresis)
- If set to 1°C: If power turns off at 30°C, it will turn ON again when the temperature drops to 29°C.
- If set to 2°C: If power turns off at 30°C, it will turn ON again when the temperature drops to 28°C.

P2 (Thermostat Upper Limit Temperature Setting)
- Allows for a double-check to prevent the temperature from exceeding a certain point if someone accidentally changes the settings.

P3 (Thermostat Lower Limit Temperature Setting)
- Allows for a double-check to prevent the temperature from dropping below a certain point if someone accidentally changes the settings.

P4 (Temperature Calibration)
- Can calibrate the sensor by ±7°C if the sensor's reading differs slightly from the actual temperature.

P5 (Delay Time)
- Allows you to delay the switch from turning on again by 0 to 10 minutes.

- No case is included, so please prepare a small container such as a plastic container from Daiso.
- Will be shipped with simple packaging via Yu-Packet Post.