Makita Hammer Drill HM0830 - Cleaned, New Grease & O-ring & Grip

This item is listed as a maintenance item.
Purchase date is unknown.
The serial number on the wiring cord is unknown.
The serial number is in the 241,000 range.

The handle grip is new and unused.
As it is still in the bag, please assemble it yourself.
Grip springs and grip bases have been reused.

*Disassembled, wiped down, and cleaned each part.
New Makita genuine grease has been applied.
O-rings in critical areas for hammer operation have been replaced with new ones.
Please refer to photos 18-20.
Carbon brush remaining amount: approx. 15mm
New carbon brush: approx. 16mm
As there is little wear and no uneven wear, they have been reused.

*Confirmed operation after maintenance by powering on.
Ran for about 5 seconds without hammer operation until grease circulated.
Repeated random operation 3 times.
Confirmed hammer operation for about 5 seconds using a bull point.
Subjectively, the hammer operation is good.

- All accessories are shown in the photos.
Dedicated case
*The corners on the top side are damaged.
Bull point 17
*There is rust and dirt.

*Please refrain from purchasing if you are overly concerned about the condition (nervous individuals).

*Priority will be given to those who purchase immediately, even if you have questions or comments.

The item will be packed with bubble wrap applied twice to the dedicated case, with the contents visible.
It will be shipped via Yamato Transport, size 120, and weighs approximately 7.5kg including the hammer drill case.

Thank you for looking.