Hole Punch Die for Hand Press Machine, 6mm Diameter, Leather Craft, Rivets, Eyelets, Snaps

Thank you for looking!
This is a 6mm diameter punching die for a hand press machine.

I bought it new from GRKS on Mercari, but it didn't fit my hand press machine after trying it out, so I've decided to sell it.
I plan to ship it via Click Post.

The following is quoted from the shop:
[Applicable Die Size]
Upper: M8 screw type (pitch 1.25)
Lower: 19mm snap-in

☆6mm Punching Die
1 set

Since it doesn't use a hammer like a punch, the operating noise is extremely quiet!!
This allows you to work without worry at night or in apartment buildings.

It can be used not only on leather but also on a wide range of materials such as canvas and bag tape.
The punching die is sharp and can easily punch through two layers of leather (approx. 3mm thick) or three layers of canvas (approx. 2.4mm thick) at once.

☆When working, do not tighten the upper die all the way. Leave a small gap and press (see image 11).
☆Please understand that we cannot answer inquiries about compatibility with your hand press machine.
☆Instruction manual is not included.
☆The current lot had dirt and rust upon arrival, so it has been cleaned and coated with rust-preventive paint.
☆The design may differ slightly from the sample image, but the hole diameter is unaffected.

Please understand that this is a personal item stored at home before purchasing.