Bench Storage Box, Bench Stocker, Seatable, With Backrest, Garage/Garden Storage, DIY

Thank you for viewing. Please be sure to read the profile section for important notes.

■ Set Contents
Main unit

■ Dimensions (approx./cm)
Outer dimensions: Width 82 x Depth 31.5 x Height 64
Inner dimensions (inside box): Width 76 x Depth 25.5 x Height 37.5
Height to lid excluding backrest: 43cm Backrest height: 30cm
Weight: Approx. 10.8kg

■ The frame is made of galvanized steel, the sides and bottom are made of siding material (wall material), the lid is made of wood-grain patterned plastic board, and the backrest is made of wooden plywood.

■ The backrest is made of wooden plywood and painted with black acrylic spray. It is connected to the lid with metal stays and is fixed.

■ Regarding the backrest, we found that it has sufficient strength for normal leaning. However, if you lean with full force or apply pressure, there is a possibility that the connection points may break rather than the board itself. Please check this yourself upon receipt and before use.

■ The lid can be secured with two snap fasteners on both sides. It is also connected to the main unit with two hinges. The snap fasteners have holes for locks, allowing you to attach a wire lock, etc.

■ The lid is strong enough for a person to sit on it, up to approximately 100kg.

■ The bottom board is attached with rivets and caulking.

■ While the bottom has been waterproofed to some extent, it is designed for use in garages or under eaves and is not waterproof. Please only bid if you understand this.

■ The lid is integrated with the backrest, so please be careful when opening the lid. The backrest is surprisingly heavy. When fully opened, the inside of the lid can serve as a small table (heavy items cannot be placed on it as there is no support underneath).