Wild Birds Small Birds Feeder Glass Window Mount Type Woodworking Handmade ?
This bird feeder is made from Yakisugi (charred cedar) wood.
Example photos of its use are included at the end.
It can be easily attached and detached from your window using suction cups.
To attach, slightly wet the surface where the suction cup will be placed.
To remove, insert a thin object like a utility knife between the suction cup and the glass to detach it easily.
The food container is detachable for easy cleaning.
A hole is also provided on the room-facing side, allowing you to observe the birds through the hole from inside your room.
The hole diameter is approximately 11cm, and it comes with a plastic dish. However, you are welcome to replace it with something else of your preference.
(For reference) Each suction cup has a weight capacity of 300g.
★ For shipping, the item will be disassembled and packaged as shown in the photos, so assembly will be required by the customer.
Since it has been disassembled once, you can easily reassemble it by aligning the 3 screws with the pre-drilled holes and tightening them gradually by about 5mm each with a Phillips head screwdriver.
★ If you wish to have it shipped assembled, the price will be 1500 yen, which is 550 yen higher due to increased shipping costs.
★ The suction cups will be attached to all 4 locations before shipping.
They are screwed in through the suction cup holes so that they can be replaced if necessary.
The approximate dimensions of the main parts after assembly are as follows:
Height: Approx. 20cm
Depth: Approx. 23cm
Width: Approx. 14.5cm
Hole diameter: Approx. 11cm
This is a handmade item by an amateur who enjoys DIY, so it may not be perfect, but it has been made with the utmost care.
We hope you will enjoy using it.
Example photos of its use are included at the end.
It can be easily attached and detached from your window using suction cups.
To attach, slightly wet the surface where the suction cup will be placed.
To remove, insert a thin object like a utility knife between the suction cup and the glass to detach it easily.
The food container is detachable for easy cleaning.
A hole is also provided on the room-facing side, allowing you to observe the birds through the hole from inside your room.
The hole diameter is approximately 11cm, and it comes with a plastic dish. However, you are welcome to replace it with something else of your preference.
(For reference) Each suction cup has a weight capacity of 300g.
★ For shipping, the item will be disassembled and packaged as shown in the photos, so assembly will be required by the customer.
Since it has been disassembled once, you can easily reassemble it by aligning the 3 screws with the pre-drilled holes and tightening them gradually by about 5mm each with a Phillips head screwdriver.
★ If you wish to have it shipped assembled, the price will be 1500 yen, which is 550 yen higher due to increased shipping costs.
★ The suction cups will be attached to all 4 locations before shipping.
They are screwed in through the suction cup holes so that they can be replaced if necessary.
The approximate dimensions of the main parts after assembly are as follows:
Height: Approx. 20cm
Depth: Approx. 23cm
Width: Approx. 14.5cm
Hole diameter: Approx. 11cm
This is a handmade item by an amateur who enjoys DIY, so it may not be perfect, but it has been made with the utmost care.
We hope you will enjoy using it.
Category
Wild Bird Feeders
Condition
New/unused
Shipping
Included in price (by seller)
From
Unspecified
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
