BETAFPV Drone Set with Storage Case
Set includes BETAFPV drone body and white controller with storage case.
- Brand: BETAFPV
- Accessories: Controller, Batteries, Storage Case
- Model: Cetus Pro Drone Body
- Controller Color: White Mode 2
- Storage Case Color: Gray
Thank you for looking.
- Batteries and instruction manual are not included.
- The motors are brushless motors, and the front two have been changed to 0802 19500kv with a 1.0mm shaft diameter to improve turning performance.
- The rear two are the default 1102 18000kv with a 1.5mm shaft diameter.
- Gemfan 40mm-3 propellers with 1.0mm and 1.5mm shafts are included.
- The controller and FPV goggles were accidentally left in direct sunlight and forgotten, so they are significantly sun-faded overall.
- OSD display is OK.
- Normally used with 1S. Not recommended, but image 5 shows an example of using two batteries connected in parallel for increased capacity.
- A hair tie rubber band, available at 100-yen shops, is attached, allowing you to secure batteries larger than 450mA that don't fit in the frame with the rubber band.
- Compatible with both BT2.0 and PH2.0 battery connectors.
Operation confirmed from pairing to hovering, slow indoor turns, and landing.
It seemed to be operating without any particular issues as it is capable of flight, but not all functions have been tested.
Please consider this for purchase only if the price is acceptable for a junk item.
- Brand: BETAFPV
- Accessories: Controller, Batteries, Storage Case
- Model: Cetus Pro Drone Body
- Controller Color: White Mode 2
- Storage Case Color: Gray
Thank you for looking.
- Batteries and instruction manual are not included.
- The motors are brushless motors, and the front two have been changed to 0802 19500kv with a 1.0mm shaft diameter to improve turning performance.
- The rear two are the default 1102 18000kv with a 1.5mm shaft diameter.
- Gemfan 40mm-3 propellers with 1.0mm and 1.5mm shafts are included.
- The controller and FPV goggles were accidentally left in direct sunlight and forgotten, so they are significantly sun-faded overall.
- OSD display is OK.
- Normally used with 1S. Not recommended, but image 5 shows an example of using two batteries connected in parallel for increased capacity.
- A hair tie rubber band, available at 100-yen shops, is attached, allowing you to secure batteries larger than 450mA that don't fit in the frame with the rubber band.
- Compatible with both BT2.0 and PH2.0 battery connectors.
Operation confirmed from pairing to hovering, slow indoor turns, and landing.
It seemed to be operating without any particular issues as it is capable of flight, but not all functions have been tested.
Please consider this for purchase only if the price is acceptable for a junk item.
Category
Others
Condition
No noticeable scratches or marks
Shipping
Included in price (by seller)
From
Unspecified
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled






