Tokyo Marui SAA Cylinder Black

This is a part for the cylinder of Tokyo Marui's SAA.
You can disassemble the SAA, replace the outer resin part of the magazine, and install this part.
You can shoot as usual after installation.

Although it is made using the FDM method, it is created at low speed with a 0.2 nozzle, so the layer lines are not very noticeable, and the appearance is quite good. Compared to the other one I am selling, the texture on the side where the cylinder is visible is smooth, and the surface has a slightly matte finish.

The material is ABS.
If requested, we can also create it in multiple colors or translucent. Full transparency is difficult to produce, so we will only create it upon request.
It can also be made without fluting.