Tanaka Gas Gun (Pegasus) Colt Python 20mm Rib Mount Rail Flat Type
This is a 20mm rib mount rail for the Tanaka Gas Gun (Pegasus System) Colt Python .357 Magnum.
*This is the normal type without a dent on the top surface. A type with a dent is also listed separately.
It is attached by inserting it into the rib holes and tightening with M1.2-3mm screws (a Phillips head precision screwdriver is required). The dimensions are a snug, tight fit. If a scope mount is permanently attached and tightened to this mount rail, the M1.2 screws may not be necessary. (The M1.2 screws will be shipped detached and secured with tape; please be careful not to lose them when opening.)
It cannot be attached to the rib hole closest to the muzzle.
The rail can be attached to the rib holes by shifting it about 1cm to either the front or back width of the rib hole.
The image shows an example of it attached to a Smolt (Smythson) Python .357 Magnum. The listing is for the mount rail (front and rear, 2 pieces as a set) only. The gun itself is not included in the listing.
As I only own a 4-inch model of the Tanaka Gas Gun (Pegasus System) Python .357 Magnum, the image only shows a 4-inch model.
This product cannot be attached to products from manufacturers other than the Tanaka Gas Gun (Pegasus System).
This product is made with a 3D printer and the material is PLA.
Please only bid if you understand that this is a 3D printed product. There may be 3D printer specific characteristics such as layer lines, print artifacts, burrs, stringing, fuzziness, printing irregularities, etc., as well as scratches from filing and fitting adjustments.
It may deform in environments above 70℃.
I am not responsible for any injuries or damages caused by this product.
Product specifications are subject to change without notice.
Please, no claims, no returns.
*This is the normal type without a dent on the top surface. A type with a dent is also listed separately.
It is attached by inserting it into the rib holes and tightening with M1.2-3mm screws (a Phillips head precision screwdriver is required). The dimensions are a snug, tight fit. If a scope mount is permanently attached and tightened to this mount rail, the M1.2 screws may not be necessary. (The M1.2 screws will be shipped detached and secured with tape; please be careful not to lose them when opening.)
It cannot be attached to the rib hole closest to the muzzle.
The rail can be attached to the rib holes by shifting it about 1cm to either the front or back width of the rib hole.
The image shows an example of it attached to a Smolt (Smythson) Python .357 Magnum. The listing is for the mount rail (front and rear, 2 pieces as a set) only. The gun itself is not included in the listing.
As I only own a 4-inch model of the Tanaka Gas Gun (Pegasus System) Python .357 Magnum, the image only shows a 4-inch model.
This product cannot be attached to products from manufacturers other than the Tanaka Gas Gun (Pegasus System).
This product is made with a 3D printer and the material is PLA.
Please only bid if you understand that this is a 3D printed product. There may be 3D printer specific characteristics such as layer lines, print artifacts, burrs, stringing, fuzziness, printing irregularities, etc., as well as scratches from filing and fitting adjustments.
It may deform in environments above 70℃.
I am not responsible for any injuries or damages caused by this product.
Product specifications are subject to change without notice.
Please, no claims, no returns.
Category
Toy Gun
Condition
New/unused
Shipping
Included in price (by seller)
From
Saitama
Customers Also Viewed
Was this page helpful?
marty.unleash.wiring disabled
