Next-Generation M4 Series CAN-CANNON Handguard

This is a CAN-CANNON (Can Cannon) style handguard for Tokyo Marui's next-generation electric gun M4 series.

Made with a 3D printer using heat-resistant PLA (HT-PLA).

Standard cans (tested with a cola can) fit snugly inside.
However, it only holds the can and does not fire it.
To insert a can, the inner barrel needs to be shortened. (The outer barrel also needs to be shortened, but the included mount alone is sufficient.)
The handguard is 190mm long, so please be sure to check if your model's barrel length will fit within the handguard's length. (It can still fire even if it doesn't fit, but it won't look as good.)
To fully accommodate the can, the inner barrel needs to be 180mm or shorter.

It is made with a certain thickness to prevent breakage during normal use, but due to its cylindrical shape and being made of resin, it is weak against lateral loads. Therefore, please remove it during transport or store it in a case where there is no lateral load.
We recommend transporting it with gas cans or similar items inside.
It is made strong enough to withstand some firm gripping.

While designed to avoid the convex part of the upper receiver (the part that secures the gas tube), I do not have a next-generation model with this convex part to test it.
Therefore, it may be necessary to remove the convex part.
It should break off easily with pliers.

The set contents are all shown in the last image.
Images other than the last one may be used for other listings, but the last image is taken specifically for this listing and shows the item that will be shipped. Please check the last image to confirm the finish.

We are also developing a separate can-shaped silencer device (availability not guaranteed).

If you are interested in any of our previously listed 3D printed products, please contact us as we may be able to remake them.